How to choose geothermal floor

The real measure is needed to heat the floor many specific technical parameters. First, it must have good heat dissipation. Geothermal floor in the choice of material is very particular about the strict selection of special substrates that meet the requirements of the wood density. Floor thickness between 6.5-8.5 mm(standard thickness to heat the floor), to ensure that the floor has good air permeability and heat dissipation. The second characteristic is the heat resistance.

Finished geothermal floor tempered into a steel actually have a little taste. In its production process must go through rigorous testing to four cycles. Namely: the floor and cook 4 hours at 100 degrees Celsius for 60 degrees Celsius hot oven 100 degrees bake 20 hours hot water and cook 3 hours 2 hours freezing minus 20 degreesCelsius. And from four to ensure long-term high-temperature floor, no cracking, no unglued, anti-moisture, no distortion, no warping. The last point is green.
Colombia wood plastic composite

Health, safety is a fundamental requirement to heat the floor. The products should comply with international environmental standards (European environmentalstandard for E1; Japanese environmental standards for F1; China release formaldehyde content of less than 0.12mg / m3 equivalent to international standards).

Because geothermal dedicated floor price is relatively expensive, generally earners hoping to find an affordable and meet the requirements of both the inexpensive products. There is introduction of several alternatives. Suitable wood floor heating systems are the following: first, 7-8 mm thick laminate flooring, with 2-3 mm foam

cushion; second, 8-12 mm thick, three or more layer parquet, with 2-3 mm foam cushion; third, 8 mm thick mosaic parquet or mosaic parquet floor, with 2-3 mm foam cushion; fourth, 10-12 mm thick flat wood flooring; fifth, length, width and height, respectively, less than 600 × 60 × 15 mm tongue and groove wood flooring, the best is 200 × 40 × 10 mm size of the floor, makes up a square or herringbone during construction making it uniform thermal deformation.
Composite wood plastic solid frames

In short, the choice of geothermal heating of wood flooring to master the following principles: the size of the wooden floor should be stable, better thermal stability, low moisture content, so that after the floor heating is not easily deformed; to be conducive to the heat exchange and conduction, cushion material should not be too thick; floor size should be thin not thick, not narrow width should facilitate resistance to deformation, thermal conductivity requirements.
Wood plastic composite wall panels dark brown