Cork flooring density, quality and maintenance

 

Cork flooring density: the density of cork flooring is divided into three 400kg-450kg / m3; 450kg-500kg / m3; more than 500kg / m3. General household selection 400kg-450kg / m3 enough, if there is heavy interior, optional slightly higher, in short, to try to choose the choice of density low density, because it has better flexibility, insulation, sound absorption, vibration absorption properties. Can i make a pergola from composite lumber

Quality cork flooring: cork flooring choices to look at whether the floor sanding smooth surface, with or without bulging particles, whether pure cork granules. Choose floor side is straight, the method is: take the same floor 4, on the glass, or on relatively flat ground, assembled view of whether the commissure. Bending strength test board, the method is the floor together two diagonal interference, whether watching his curved cracks, no was quality product. Bonding strength test. The way the sample into a small open blisters, found sanding smooth surface becomes like a toad skin, uneven surface, this product is substandard goods, quality product in case of water surface should be no significant change. Lightweight porch flooring

 

Cork flooring maintenance: Maintenance of cork flooring easier than other wood flooring, during use, should avoid daytime indoor sand into individual sand into, it will not affect the wear, so when the sand into, and is pressed into the foot pressed into the elastic layer, when the pace to leave, will be ejected. Of course, here to remind, not too much into the dirty sand, it will produce flow wear, therefore, into the sand, although after the impact, but excessive wear, therefore, into the interior of the sand should be promptly removed and does not require vacuum cleaner, do not worry moisture will warp, mildew and other phenomena. If used for high traffic situations, three, five years if the individual office wear, you can make up for local adoption, namely the local office again added coating, the method is very simple, in the fray lightly with sandpaper, remove it fouling surface, then use a dry, soft cloth to gently wipe clean and re-coat coating system, or in the local place to stick the polyester film. How to build an above ground pool deck using composite materials